Care & setup
Start with a full charge.
The PL-E01 arrives with a battery installed. Charge it over USB-C before the first long night out, and check the tail cap is fully tightened.
Check the battery
Open the tail cap and confirm the 18650 is seated. Follow the polarity marks inside the cap — do not force it. Replace the cap and tighten it fully; the light needs a firm contact to run.
Charge over USB-C
Lift the port cover, connect the supplied cable to any USB-C adapter, and charge for about three hours. The switch glows red below 25%. Close the port cover fully before the light gets wet.
Turn it on and change modes
Long-press the switch for on and off. A single click cycles High, Medium, Low and Strobe with SOS.
Carry it without a surprise
Use the lanyard or the pocket clip, and keep the switch away from keys and tools. If the light will sit unused for months, remove the battery and store it at room temperature.
Clean it properly
Wipe the body with a damp cloth and mild soap. Keep water out of the USB-C port. Inspect the O-rings at the tail cap and port cover; a dry O-ring can be wiped with a tiny amount of silicone grease.
Charging & runtime.
The battery is a replaceable 3200 mAh 18650. Runtime depends on mode, temperature and battery age; the figures below are the rated values.
- High800 lumens3.7 h
- Medium500 lumens11.7 h
- LowClose work40 h
- Strobe with SOS8 h
- Charge timeUSB-C, from empty≈ 3 h
- BatteryLi-ion, replaceable3200 mAh 18650
Use a normal 5 V USB-C adapter. A very high-wattage laptop charger will not make it charge faster; the light draws what it needs.
If something is wrong.
Try these before you write to us. If the light still misbehaves, send a photo and the purchase date and we will take it from there.
It will not turn on.
Charge it for an hour, check the tail cap is fully tightened, and confirm the battery is seated in the right direction. If you have another 18650, try it — that separates a battery problem from a light problem.
It flickers or changes mode on its own.
Clean the threads and the contact at the tail cap with a dry cloth. Check that the cap is tight. If the flicker continues, stop using it and write to support.
It will not charge.
Try a different USB-C cable and a different adapter. Check the port for lint or debris with a wooden toothpick — never metal. Make sure the port cover is open far enough for the plug to seat.
The runtime is shorter than the rated figure.
Cold weather, an older battery and repeated high-mode use all reduce runtime. Try a fresh 18650 before assuming the light is faulty.
Water got inside.
Stop using it, remove the battery, and leave the tail cap off in a dry place. Do not charge it. Write to support with a photo and we will advise on the next step.